Combined air and dirt separator

1. Built-in unique filling material 2. combined air and dirt separator 3. remove air and dirt from cycle water system 4. HVAC

The life and efficiency of a heating or cooling system are greatly dependent on the quality of the system water. Air and dirt problems cause frequent breakdowns and increased customer complaints. Corrosion, cavitation, and component wear are consequences of air-saturated, dirty system water.

Recurring problems and increased maintenance results in unnecessary costs and dissatisfied owners.

There is a solution

A system without air and dirt is possible! There is a unique dual-purpose device named Combined air and dirt separatorthat will remove air and dirt down to the smallest particle, keeping the system free from air and dirt, permanently. It works differently over traditional filters, with less maintenance and fewer costs.

Distinguishing features• Water throughout the device can protectsystem to greatest extent• Improved efficiency• Reduce the risk of system failure• Increased component life• Reduced oxygen-based corrosion andpump cavitation• Quiet operation• No bypass, isolating valves orreplacement filters to clog and reducepressure drop• Dirt can be flushed while system isoperating

Install the device for optimum performanceMicrobubble is mostly released when system temperature is to the highest base on Henry’s Law, which states that air is released from water as the temperature increases or the pressure decreases. For this reason, the Microbubble deaerators and dirt separators is typically installed in the hottest point in the system. For a heating system, installation should be in the outlet pipe of the boiler. For cooling system, the hottest point is on the water return pipe. When for dirt clean use, the most important conditions are the separation performance of microbubble, not the location of device installation.

Combined air and dirt separator